I just found this and thought I'd share it with all those who love to feed the birds, might try and make one myself...

Bird feeder

A simple and easy bird feeder can be made from a short piece of 4-inch PVC pipe, an end cap, some stiff wire, and an old pie pan.

First, cut your pipe in the length that you want your feeder to be; 14 to 18 inches is good. Slide the end cap onto one end of the pipe. Just below where the cap fits, drill a couple of small holes that will take a piece of wire that the feeder will be suspended by.

PVC feeder: make a pvc bird feeder for all those birds you love to feed.

On the other end, saw out a few notches around the circumference of the pipe. A couple of inches up from this end, drill two more small holes.

Drill two small holes in the bottom of the pie pan at points that will line up with the last two holes you drilled in the pipe, or close to it. Now, run each end of a length of wire from the pan bottom up and through the small holes, from the inside out. Bend the ends of the wire down to securely hold the pan in place.

You can see in the illustration that the wire will hold the pan in place while the notches that you cut in the bottom of the pipe will allow bird feed to settle into the pan. It is also a good idea to drill several small holes in the pie pan to allow rainwater to drain from it.

Cut a piece of wire to use as the hanger. Bends on each end of the wire are inserted into the holes near the top of the pipe. Now just remove the end cap to fill the feeder, then hang it in a good spot near some cover. The birds will soon find it.